Hartan VIP GTS/Yes Manuel D'instructions page 9

Instructions for use
WARNING!
When opening out and folding down the frame and when adjusting the back-rest,
pinch-points may be caused in which fingers etc. can be trapped unless care is exercised. Ensure that
your child has plenty of clearance space.
unfolding the carriage
Lift the handle 1 until the two lateral handle catches 2 have engaged.
WARNING!
Before using the pram, make sure all catches are locked. Take care that you keep your
child's body parts at a safe distance.
Folding the carriage
Turn the twist grip 3 inwards and push at the same time the telescopic handle to the stop. With the grip 3
still twisted, depress the red button 21, and push the handle 1 forcibly until it disengages.
Height-adjustable Telescopic handle
Turn the twist grip 3 inward and slide the handle 1 in the desired position until it engages on both sides.
Changing the rear wheels
Release the parking brake 7. Depress push button 4 and pull the wheel off. Push the wheel right to the
axle's stop. Make sure, all wheels are held in place properly. Then, depress the button again.
Lock-type-swivel wheels
Turn down the lock lever 5 to pre-select the straight-line motion mode, which will be
activated the moment the wheels point in forward direction. To allow the wheels to
swivel freely again, turn the lever 5 back to the horizontal position. On very uneven
surfaces, and when going very fast, we recommend locking the swivel movement, to
prevent the wheels from blocking.
Changing the swivel wheels
To remove the wheel, release the push-button in the centre of the cap 6 and pull the wheel off the holding
device. To assemble the wheel, insert the fastening pin in the holding device, and engage it by a forcible
push, which is indicated by a click sound.
Parking brake
Push the red brake button 7 to engage the brake. Having parked the
pram, try to push it to check the brake. Push the green brake button
7 to release the brake.
WARNING!
Make sure the
brake is always closed when placing the baby in the carriage or
taking it out of it.
Adjustable suspension system
By turning the selector 8, a „hard" or „soft" position can be
selected for suspension.
Climatic zone 10
To provide good ventilation to the hood
and to prevent heat from accumulating inside, open the two zip fasteners
28 and fold up the hood flap. Use the Velcro band below the additional
tap to secure the flap to the hood. As an additional protection, the sun
visor 20 can be pulled out.
Hood and safety bar
By pressing the bayonet joint 12, the hood or the safety bar can be pulled
out. When inserting it, make sure the safety bar locks into place correctly
and be careful not to pinch any of the fabric parts. By pressing the buttons
11, the safety bar position can be changed.
WARNING!
The hood bar of the stroller and the safety bar are not suitable for carrying the stroller.
Adjusting the backrest
By raising adjustment lever 13 on the back, the seat-back can be precisely adjusted to any incline between an
upright seated position and a lying position.
movable parts jam the baby's limbs or fingers, etc. Finally, make sure the backrest has reengaged properly.
8
WARNING!
When adjusting the backrest, take care that no
5
8 7 8
Additional tap
28