ProMed tens 1000 s Mode D'emploi page 38

tens1000s_manual_020505 02.05.2005
C
ONNECTING THE
1. Preparing the skin
Prepare the skin as described above and in the instructions that came
with the electrodes. Position the electrodes in the area recommended
by your doctor.
2. Connecting the leads to the electrodes
Connect the leads to the electrodes before attaching the electro-
des to the skin.
Make sure that the intensity regulators 2 for both chan-
Caution:
nel 1 and 2 are in the "
OFF
3. Attaching the electrodes to the skin
Attach the electrodes to your skin in the manner recommended
by your doctor.
12:05 Uhr Seite 38
T U
ENS NIT
" position.
4. Connecting the leads to the TENS unit
Plug the lead into the appropriate channel socket, pushing the
plug as far as possible into the socket (see "
").
ectrode leads
5. Selecting the settings for treatment
Make sure that the settings selected on the unit are those recommen-
ded by your doctor.
6. Setting channel intensity
The intensity regulator 2 is to be found on the upper side of the
unit. Turn the control knob for channel 1 or 2 in a clockwise di-
rection. The power LED will light up when the unit is switched
on. Slowly turn the control knob in a clockwise direction until
you reach the intensity setting recommended by your doctor. If
both channels are being used, repeat the same procedure for
the other channel.
Connecting the el-