ProMed tens 1000 s Mode D'emploi page 32

tens1000s_manual_020505 02.05.2005
C
ONNECTING THE
The leads supplied with the TENS unit are to be connected to
the sockets on the upper side of the unit 1. Hold the plug by the
insulated part and push the end of the plug into one of the
sockets. You may use one or two sets of leads. After you have
connected the leads to the stimulator unit, connect an electrode
to each lead 2. The leads supplied with the TENS unit conform
to the FDA Compliance Standards.
Please note:
Take care when connecting and removing leads. If you pull on
the lead rather than holding the insulated part of the connector,
the lead may be damaged.
Caution:
Never plug the lead into an AC (alternating current) outlet.
12:05 Uhr Seite 32
E L
LECTRODE EADS
Sockets for the electrode leads
left channel and right channel
1
Lead plugs
(the same for both channels)
2
Electrode plugs