Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Auto-burst function
Hold the activation button to deliver bursts continuously, approximately
one second between set of bursts.
1
To switch off the AirFloss Ultra, press and hold the power/mode
button for one second.
Automatic shut-off function
The AirFloss Ultra automatically switches off if it has not been used for
one minute.
Cleaning
If the AirFloss Ultra becomes clogged, or to clean the inside of the
AirFloss, fill the reservoir with warm water and press the activation
button until the reservoir is empty.
Do not clean the nozzle, handle or charger in the dishwasher.
Do not use cleaning agents to clean the appliance. The formulation or
strength of some agents may damage the appliance.
Handle and nozzle
1
Remove the AirFloss Ultra nozzle from the handle. Rinse the nozzle
after each use to eliminate the residue left in it (Fig. 16).
2
Open the reservoir and rinse it under a faucet to eliminate
residue (Fig. 17).
Tip: You can also use a cotton swab to wipe the reservoir and remove the
remaining residue.
Note: Do not immerse the handle in water.
Note: Failure to remove residue from the nozzle or reservoir may result in an
unhygienic condition.
3
Wipe the entire surface of the handle with a damp cloth (Fig. 18).
ENGLISH
11
Publicité
Table des Matières
