MSI 970A-G43 Serie Mode D'emploi page 43

▶ DRAM Frequency
Ths tem allows you to adjust the DRAM frequency.
▶ Adjusted DRAM Frequency
It shows the adjusted DRAM frequency. Read-only.
▶ DRAM Tmng Mode
Select whether DRAM tmng s controlled by the SPD (Seral Presence Detect)
EEPROM on the DRAM module. Settng to [Auto] enables DRAM tmngs and the
followng "Advanced DRAM Configuraton" sub-menu to be determned by BIOS based
on the configuratons on the SPD. Selectng [Lnk] or [Unlnk] allows users to configure
the DRAM tmngs for each channel and the followng related "Advanced DRAM
Configuraton" sub-menu manually.
▶ Advanced DRAM Configuraton
Press <Enter> to enter the sub-menu.
▶ Command Rate
Ths settng controls the DRAM command rate.
▶ tCL
Controls CAS latency whch determnes the tmng delay (n clock cycles) of startng
a read command after recevng data.
▶ tRCD
Determnes the tmng of the transton from RAS (row address strobe) to CAS
(column address strobe). The less clock cycles, the faster the DRAM performance.
▶ tRP
Controls number of cycles for RAS (row address strobe) to be allowed to pre-charge.
If nsufficent tme s allowed for RAS to accumulate before DRAM refresh, the DRAM
may fal to retan data. Ths tem apples only when synchronous DRAM s nstalled
n the system.
▶ tRAS
Determnes the tme RAS (row address strobe) takes to read from and wrte to
memory cell.
▶ tRFC
Ths settng determnes the tme RFC takes to read from and wrte to a memory
cell.
▶ tWR
Determnes mnmum tme nterval between end of wrte data burst and the start of a
pre-charge command. Allows sense amplfiers to restore data to cell.
▶ tWTR
Determnes mnmum tme nterval between the end of wrte data burst and the start
of a column-read command; allows I/O gatng to overdrve sense amplfies before
read command starts.
En-31