DeWalt DXDP610310 Mode D'emploi page 6

English
Coiled Tool Lanyard DXDP710900
0,91 kg
WARNING:
Do not attach multiple tools to the
wrist band tool holder, that combined, may exceed
the 2 lbs/0.91Kg. maximum rating.
For adding additional tool
to your wrist band, attach
the spring lanyard to the
D-Ring of the wrist band.
Connect the carabiner
of the spring lanyard to
the D-Ring of wrist band
holder. Now the wrist band
is ready for use.
Make sure wrist strap
stays secure on your wrist.
It must not slip over your
hand.
8
MAX
Clip to Loop Spring Lanyard DXDP711100
2
2
LBS
WARNING:
Never cut the tape
on top of the lanyard, it could
weaken the structure of the
lanyard resulting in an accident.
The spring lanyard is
used for additional tool
attachment. It comes with
a clip on one end and an
adjustable thread loop at
the other. Simply attach
the clip to the D-ring
provided on the mobile
holder.
The adjustable thread loop
can be cinched around
equipment mobile clip,
which helps increase the
security of the equipment.
NEVER modify tools to create attachment points.
MAX
Single / Double Legged Tool Lanyard
2
2
LBS
0,91 kg
WARNING:
Do not wrap lanyard around, or
across your neck.
WARNING:
Do not attach by looping or knotting
the lanyard.
NOTICE:
Prior to using this product, user must ensure
that the tool to be attached on the lanyard is tightly
taped with the appropriate connector.
Make sure you tape the
webbing connector on
the tool .
Attach the desired tool to
the lanyard loop.
Now attach the carabiner
of the tool lanyard to the
D-ring of the waist belt of
the harness.
Tool lanyard is ready for
use.
Not for use with power
tools.
English
Please follow the same instructions mentioned for the
single leg lanyard.
This tool lanyard has two ends, one end comes with pre-
installed carabiner and the other with a loop.
9