Preparing To Work; After Work Is Terminated - TSM GRANDE BRIO RIDE ON 145-850 Instructions Originales

GRANDE BRIO RIDE ON 145
OPERATING MANUAL

6.1 Preparing to work

Prepare the machine for operation (Read chapter "6 PREPARING THE MACHINE")
1.
2. Sit on the driver's seat and adjust the position seat.
3. Connect the battery connector.
4. Turn the key-operated switch in ON position.
5. Control the forward and reverse switch on the console.
6. Regulate the water flow through the related lever on the footplate or adjust the flow through the potentiometer on the
console (available only on the Plus version).
7. Lower the scrubbing deck by pressing the switch on console. By pressing on the accelerator, brushes start to rotate.
8. Lower the squeegee lever or press the vacuum switch on the console (available only on the Plus version).
9. Select thr forward maximum speed by turning the knob. The selector has continuum of positions, indicated by symbols:
snail = slow speed, rabbit = fast speed.
10. By pressing the accelerator pedal, the machine starts to move. During the first few meters of work, check that the water
flow is right and that the squeegee dries the floor accordingly.
11. Adjust brushes pressure. By unscrewing the hadwheel the pressure increases, whereas by screwing pressure lows.
12. Now the machine will start to work in perfect efficiency until the water in the solution tank is finished.
WARNING
- Before starting the machine, check all the controls and safety devices to use it in the most appropriate
way. Avoid climbing over objects, holes along the course.
Do not put your hands, feet or any other object near the moving brush.
When the battery charge level is about to run out, the minimum calibration voltage appears on the display and the
first segment of the LED bar flashes and the brush and vacuum motors switch off automatically; it is therefore
necessary to recharge the machine as soon as possible.
Should any problems arise during work, turn off the key, press the emergency button. These commands will block
every moving part of the machine. To resume operations, once the problem has been resolved, turn off the machine
using the ignition key, lift the emergency button, and turn on the machine.
When making reverse movements, even if short, lift the squeegee.
Do not move the machine too fast.
6.2 Recovery tank full
The hourcounter on the console of the machine has an overflow led
to be emptied before starting to work again.
6.3 Traction
This machine has an electronically controlled traction system.
To move the machine first turn the key-operated switch in ON position and press the accelerator pedal. Check the machine
direction with the appropriate selector. The speed can be adjusted by turning the speed potentiometer.
WARNING
- To avoid wear of the squeegee blades or any damage to the squeegee, reverse gear must be carried
out with the squeegee lifted off the ground. If the machine is equipped with the automatic lifting of the squeegee in
case of reverse, the machine will move only when the lifting is completed (available only on the Plus version).
6.4 Brakes
The machine has an electronic braking system. To brake, in normal conditions, just remove the foot from the accelerator pedal.
Machine is normally braked, the brake could be released by applying these options:
1. Turn the key-operated switch in ON position;
2. Pushing accelerator pedal;
3. Sitting on the seat.
If required the brake on the drive motor can be realese by screwing the handwheel on the driving wheel.
6.5 Flashing light (optional)
The machine can have a flashing light that turns on automatically when turn the key-operated switch in ON position.
6.6 Linear actuator of the scrubbing deck
The machine has a linear actuator, which automates the function of lifting and lowering the scrubbing deck. To lower/lift the
scrubbing deck push the related switch on the console. By pressing on the accelerator the movement of the brushes will start.

7 AFTER WORK IS TERMINATED

that detects when the recovery tank is full and required