STERWINS UP20 Notice De Montage, Utilisation Et Entretien page 175

Problems
The machine
vibrates at high
speed
Pendulum bearing & Gear
while cutting without the
Thickness of branches
hard for the machine or
The motor stops
while operating
The battery is discharged
The machine is protected
The machine has damage
The Motor is ON,
blades do not
move
The blades are blocked
Probable causes
The blade is out of
balance or worn
The motor shaft is
twisted
The oscillator arm is
twisted
box is damaged
The claw holder is not
close to the branches
claw
exceeds capacity
Wood or material too
blade is not adapted
due to over load
175
Solutions
Change the blade
Turn off the motor and
inspect the machine.
Get the machine
repaired.
Turn off the motor and
inspect the machine.
Get the machine
repaired.
Turn off the motor and
inspect the machine.
Get the machine
repaired.
Keep the claw holder
close to the branches
Only cut branches
complying with the
capacity
Only cut material
complying with the
capacity and with a
blade adapted to the
work
Recharge the battery
Turn off the machine,
move the machine out
of the working area,
start again
Do not use the machine
and speak to service
center
Remove battery pack
then clear blockage
from the blades
Qualification
-
Approved
repair centre
Approved
repair centre
Approved
repair centre
-
-
Approved
repair centre
-
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN