Troubleshooting; Scrapping - Nilfisk Alto SCRUBTEC 343B Manuel D'utilisation

ENGLISH

TROUBLESHOOTING

Trouble
The motors do not turn on; no warning light turns
on
The warning lights (62, 63, 64) fl ash
simultaneously
The vacuum system motor does not turn on
The dirty water vacuuming is insuffi cient
The solution fl ow is insuffi cient
The squeegee leaves marks on the fl oor
For further information refer to the Service Manual, available at any Nilfi sk Alto Service Center.

SCRAPPING

Have the machine scrapped by a qualifi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force:
– Battery
– Brushes
– Plastic hoses and components
– Electrical and electronic components (*)
(*) Refer to the nearest Nilfi sk Alto Center especially when scrapping electrical and electronic components.
24
USER MANUAL
The battery terminals (50) are disconnected
The batteries (50) are discharged
The brush motor is overloaded
There are foreign materials (tangled threads,
etc.) preventing the brush from rotating
The fuse is blown
The recovery water tank (31) is full
The vacuum grid (46) is clogged or the fl oat
is closing
The vacuum hose (22) is disconnected from
the squeegee (11) or it is damaged
The squeegee (11) is dirty, or the squeegee
blades (13, 14) are worn or damaged
The recovery water tank cover (6) is not
properly closed, or the gasket (42) is
damaged
The recovery water tank (31) is dirty (clogged
drain hole)
The solution fi lter (20) is dirty
There is debris under the squeegee blades
(13, 14)
The squeegee blades (13, 14) are worn,
chipped or torn
SCRUBTEC 343B
Possible Cause Remedy
Connect
Charge
Use a different kind of brush
Clean the brush hub
Replace
Empty
Clean the grid and check the fl oat
Connect
Clean the squeegee or replace the blades
Check and/or clean the seating surface or
replace the gasket
Clean
Clean
Remove the debris
Replace the blades
909 6313 000(4)2009-11 A