Machine Transport/Parking - Nilfisk Alto SCRUBTEC 343B Manuel D'utilisation

Battery discharge during operation
4. Until the green warning light (62) stays on, the batteries allow the machine to work normally. When the green warning light
(62) turns off and the yellow (63) and red (64) warning lights turn on in sequence, it is necessary to charge the battery as the
machine residual autonomy is at the minimum level.
WARNING!
Do not use the machine with discharged batteries, to avoid damaging the batteries and reducing the battery life.
Machine speed adjustment
5. The machine speed varies according to the type of fl oor to be cleaned and the choice of using the brush or the pad. If
necessary, it is possible to adjust the machine speed, according to the procedure shown in Maintenance chapter.

MACHINE TRANSPORT/PARKING

To transport/park the machine, proceed as follows.
1. Turn the brush/pad-holder switch and the vacuum system switch (65 and 66) to "0".
2. Lift the squeegee with the lever (19).
3. Grasp the handlebar (2) and slightly lower it until the rear wheel (7) comes into contact with the fl oor (Fig. 4). While holding the
machine in this position, drive it to the transport/parking area.
4. In order not to drag the brush/pad on the fl oor and leave wet marks, when fi nishing working, remove the brush/pad-holder from
the deck by using the release device (see the procedure in After Using The Machine paragraph), then place it on the support
(30).
909 6313 000(4)2009-11 A
USER MANUAL
Figure 4
SCRUBTEC 343B
ENGLISH
S311225A
15