Ryobi TS1143L Manuel D'utilisation page 18

work surface. Practice will teach you the correct position for
aligning your mark with the laser line.
To adjust the position of the laser guide line, refer to the
Adjustments section later in this manual.
NOTE: Many of the illustrations in this manual show only
portions of the compound miter saw. This is intentional so that
we can clearly show points being made in the illustrations.
Never operate the saw without all guards securely in
place and in good operating condition.
SQUARING THE BLADE TO THE FENCE
See Figures 16 - 21.
 Unplug the saw.
 Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
 Unlock the miter lock lever.
 Rotate the miter table until the pointer aligns with zero
dentent on the miter scale.
 Lock the miter table.
 Loosen bevel lock knob and set saw arm at 0° bevel
(blade set 90° to miter table). Tighten bevel lock knob.
 Lay a square flat on the miter table. Place one leg of the
square against the fence. Slide the other leg of the square
against the flat part of saw blade.
BLADE
MITER
FENCE
SQUARE
VIEW OF BLADE SQUARE WITH FENCE
MITER
LOCK HANDLE
MITER
TABLE
ASSEMBLY
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
 The edge of the square and the saw blade should be
parallel as shown in figure 16.
 If the front or back edge of the saw blade angles away
from the square as shown in figures 17 - 18, adjustments
are needed.
SQUARE
SOCKET HEAD
SCREW(S)
MITER
FENCE
VIEW OF BLADE NOT SQUARE WITH FENCE,
SQUARE
SOCKET HEAD
SCREW(S)
MITER
FENCE
VIEW OF BLADE NOT SQUARE WITH FENCE,
Fig. 16
18 - English
BLADE
MITER
TABLE
ADJUSTMENTS ARE REQUIRED
BLADE
MITER
TABLE
ADJUSTMENTS ARE REQUIRED
Fig. 17
Fig. 18