Removing The Filter Assembly - Aerus PURE & CLEAN A1040A Mode D'emploi

UNINSTALLING THE OPTIONAL HEPA FILTER SHEET (CONTINUED)
1a. Remove the Filter Assembly (see
below).
1b.
Remove the HEPA Filter Sheet on top
of the Prefilter.

REMOVING THE FILTER ASSEMBLY

WARNING: Unplug the unit before performing any maintenance procedures.
WARNING: Do not operate the Aerus Pure & Clean without the Filter Assembly and Back Cover properly installed.
1. Unplug unit.
4. Press the tab down release
the Filter Assembly.
2. Replace the Filter Assembly,
inserting the bottom of the Filter
Assembly first.
2. Press the top of the Back Cover to
release the back panel.
5. Lift the Filter Assembly up and
out to remove.
3. Replace the Back Cover
by inserting the bottom
in first and snapping
into place.
3. Lift up to remove the back
panel.
9