Operation; Placement Of Unit - Aerus PURE & CLEAN A1040A Mode D'emploi

Système de purification de l'air portable
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPERATION

1. Adjust the fan speed to your preference, keeping in mind that higher fan speeds will give better results.
2. Using the A·PURE/A·PURE x2 button, set the unit to A·PURE, for typical use, or A·PURE x2, for increased smoke and odor control.
A·PURE MODE: The unit's display shows the fan speed (low to high) and
A·PURE to indicate that the ActivePure® Cell and ionization are both
functioning normally.
A·PURE x2 MODE: A·PURE x2 lights up, indicates that (2) ActivePure® Cells and
ionization are both functioning normally.
ION MODE: Ion lights up, indicates only ionization is functioning.
POWER OUTAGES: Memory before power off settings.

PLACEMENT OF UNIT

CAUTION: To prevent injury, be sure the power cord is not accessible to small children.
Suggested locations listed in the order of preference:
1. Nearest the source of the worst pollution.
2. Near a cold-air return to thoroughly circulate the benefits of your Aerus Pure & Clean
throughout the area.
x2
3. In the area most heavily used to achieve maximum benefit.
NOTE:
The rear of the unit should always have at least one inch of open area to allow
unrestricted airflow.
Fan Speed
x2
x2
Fan Setting
ActivePure®
Setting
x2
5

Publicité

Chapitres

Table des Matières
loading

Table des Matières