Important Safety Instructions - Aerus PURE & CLEAN A1040A Mode D'emploi

IMPORTANT SAFETY INSTRUCTIONS

WARNING:
• When using electrical appliances, basic precautions should always be followed to reduce risk of fire, electric shock, and
injury to persons, including the following:
• Eye damage may result from directly viewing the light produced by the lamp used in this product; always turn off & unplug
unit before removing filters or bulbs
• Do not operate this unit without the Filter Assembly AND Back Cover installed
• Disconnect power cord before servicing
CAUTION: • Allow your Aerus Pure & Clean to warm to room temperature before operating; damage may result from turning on a
cold unit
CAUTION: Do not operate unit near heat sources, open flame, or combustible vapors or gases.
Read this manual in its entirety before using your Aerus Pure & Clean
• NEVER locate air cleaner where it may fall into a bathtub or other water container; to protect against electrical hazards, DO NOT immerse in
water or other liquids
• DO NOT touch the control panel or plug with a wet hand
• DO NOT run cord under carpeting; DO NOT cover cord with throw rugs, runners, or similar coverings; arrange cord away from traffic area and
where it will not be tripped over
• DO NOT insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the
air cleaner
• To prevent a possible fire, DO NOT block the air intakes or exhaust in any manner; DO NOT use on soft surfaces, like a bed, where openings
may become blocked
• To avoid fire or shock hazard, plug the unit directly into an electrical outlet
• To disconnect air cleaner, turn controls to OFF, then remove plug from outlet; pull firmly on the plug, DO NOT unplug by pulling on the cord
• Always unplug the unit before moving or cleaning, or whenever the air cleaner is not in use
• DO NOT use outdoors or on wet surfaces
• DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit, doing so will void your warranty
• Connect to properly grounded outlets only
• To reduce the risk of electrical shock, do not change the plug in any way; do not use adaptors
SAVE THESE INSTRUCTIONS
3