How To Wire Your Industrial Fan - Luminance Brands kathy ireland HOME PRO Serie Mode D'emploi

5. How to Wire Your Industrial Fan

If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan
installed by a licensed electrician.
WARNING
!
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
5.2
Place the Electronic Receiver into the opening of the
Hanger Bracket above the Hanger Ball. Continue to
insert the body of the Receiver (flat side facing up) into
the opening, orient as shown. Be careful not to pinch
any Wires between the Receiver body and the Bracket
or Ball (Figure 15).
WARNING
!
To avoid possible fire or shock, do not pinch the
antenna wire between the hanger bracket and the
receiver.
5.1
CAUTION: To reduce the risk of electrical shock,
disconnect the electrical supply circuit before
installing the fan or receiver.
Disconnect Electrical Power to the Branch Circuit at the
Circuit Breaker or Fuse Box before attempting to Wire
the Ceiling Fan.
!
This product is designed to use only those parts
supplied with this product and/or any accessories
designated specifically for use with this product
by Luminance Brands. Substitution of parts or
accessories not designated for use with this product
by Luminance Brands could result in personal injury
or property damage.
HANGER
BRACKET
HANGER
BALL
Figure 15
10
WARNING
RECEIVER
ETL Model No.: HF1161