Russell Hobbs 20240-56 Mode D'emploi page 4

C FIT THE LID
13 Hold the lid over the jug, with the safety switch to the right of the handle.
14 Lower the lid on to the jug.
15 Turn the lid clockwise to bring the safety switch into the gap at the top of the handle.
16 The controls will only operate with the lid and jug in this position.
17 The jug will not move while the safety switch is engaged.
18 To release the jug, you must first turn the lid to bring the safety switch to the right of the
handle.
, Don't try to move the lid or the jug while the motor is running.
C SWITCH ON
19 Check that the speed control is set to Y.
20 Put the plug into the power socket.
C SPEED CONTROL
21 Turn the speed control to the speed you want (1 = low, 3 = high).
22 Turn the speed control back to Y to turn the motor off.
23 Turning the speed control anti-clockwise to Y will give you a short burst at high speed. In
this direction, the knob is spring-loaded. When you let go, it'll return to Y.
O SPEED CONTROL
• The light will change colour as the speed changes.
1 blue
2 purple
3 green
Y
red
24 To add ingredients while the motor is running:
a) lift the pusher out of the tube
b) add the ingredients via the tube
c) replace the pusher
s WITH THE DISCS
25 Remove the lid.
26 Remove the support, and fit the disc to the top of the spindle.
27 For fine grating, fit the fine grater with the rough side on the top of the disc.
28 For slicing, the slicing blade must be on top of the disc.
29 For coarse grating, the slicing blade must be on the bottom of the disc.
30 Replace the lid.
31 Remove the pusher, and drop the ingredients down the tube.
32 Replace the pusher, and use it to push the ingredients gently down the tube.
33 Don't use fingers or cutlery to push food down the tube – only the pusher.
34 The blade(s) on top of the disc will slice or grate the food into the jug.
35 Don't let the jug get more than about half full – stop and empty it.
N USING THE BLENDER
36 Align the d on the bottom of the jug with the U on the motor unit.
37 Lower the jug on to the motor unit, then turn the jug to align the d with the L.
38 Remove the lid.
39 Put the ingredients into the jug.
40 Don't fill past the1500ml mark. If you do, the contents may force the lid off when you start the
motor.
41 Replace the lid.
42 Align the pips on the cap with the slots in the hole, fit the cap, and turn it clockwise to lock it.
slicing/ shredding/ grating
dough/ cakes/ cream
blending/ other
chopping/ smaller batches
4