Function Test - GEZE Slimdrive SD Notice De Montage

Integrierte Schließfolgeregelung Bandseite Slimdrive SD Mat. Nr. 83221, Datei 83221 SD_IS-BS_141199.p65
NOTE:
1st closing leaf DIN left – rope at the bottom
1st closing leaf DIN right – rope at the top
Insert one end of the rope into valve lever of Slimdrive SD-IS
(1 closing leaf). If an intermediate cover is used, run rope through the
st
ventilating holes of the side elements of the drives, then pull towards
the driver at the drive of the 2
If the 2 closing leaf is open, slightly stretch the rope without
nd
tension, pull up driver and clamp rope in driver using locking
screw M2.
Illustration: Rope at the bottom of 2
Open 1 closing leaf, 2
st
The rope must be stretched and must have adjusted the valve
lever as illustrated.
If the 2 closing leaf is moved, the valve lever has to find the
nd
shifting point within a range of variation of approx. 5° to the
perpendicular.
12
Installation of rope
closing leaf.
nd
Illustration: Rope stretched
(Graphics: Valve lever in starting position)
Stretching the rope

Function test

closing leaf remains closed:
nd
nd closing leaf DIN right
Shifting offset 5°30'
90°
8°
5° Range of
variation
Shifting point