Changing A Stored Name And/Or Phone Number - Sony SPP-S9101 Mode D'emploi

4
Press (PGM).
"ENTER NUMBER" appears.
5
Enter the phone number.
You can enter up to 20 digits, including a tone
and a pause, each of which is counted as one
digit.
When the phone number of 17 digits or more
has been entered, the phone number appears in
two lines.
6
Press (PGM).
You hear a long confirmation beep, and the
name and the number are stored. The display
goes off.
Notes
• If you try to save a 101st phone number, you will hear five short error beeps
and "MEMORY FULL" will be displayed. You cannot store the phone
number. To store another phone number, erase one of the stored phone
numbers (see page 24).
• Do not allow more than 20 seconds to elapse between each step of the
procedure.
Tips
• When the phone number of 17 digits or more has been entered, "–" is
displayed next to 15th digit in step 6.
• If you have entered a wrong name or number in step 3 or 5, turn Jog Dial
down to erase it. Then enter the correct name or number.
• You may press Jog Dial instead of (PGM) in steps 4 and 6.
• To store a number to be dialed via PBX, follow the steps on page 21 when
entering a phone number.

Changing a stored name and/or phone number

1
Display the name and phone number you want
to change by doing steps 1 and 2 on page 25.
2
Press Jog Dial.
SONY
1234567
1234567890123456
12
SONY
1234567
DIAL EDIT ERASE
1234567
continued
Telephone Features
23 US