Mitsubishi Electric Lossnay LGH-F300RX5-E Mode D'emploi page 3

Maintenance
Remove all dust and dirt on air filters and Lossnay cores at regular
intervals in order to prevent a deterioration in the Lossnay functions.
Guideline: Clean the air filters once a year.
(or when [FILTER] and [CLEANING] are indicated on the remote
controller)
Clean the Lossnay cores once two year.
(Clean the Lossnay cores once a year If possible.)
(Frequency should be increased depending on the extent of dirt.)
Removing the parts
1) Maintenance cover
Locate and remove the cover fixing screw. Pull back the hinged clip.
Open the door and lift off of the hinge brackets.
Maintenance cover
Hinge
Hinge
bracket
Models LGH-F300, F470, F600RX
2) Lossnay cores
Take hold of the handle and draw the Lossnay cores out from the main
unit.
Models LGH-F300, F470, F600 RX
Model LGH-F1200 RX : ................................................................. 4 cores
5
Lossnay core
Handle
Main unit
Air filter
Models LGH-F300 ,F470, F600RX
3) Air filters
After pulling out the Lossnay cores, undo filter guides, then remove the
air filters, located at the bottom left and right of the Lossnay cores, as
below.
Models LGH-F300 , F470, F600 RX
Model LGH-F1200 RX : ................................................................ 8 filters
5
Filter stopper
CAUTION
Bow filter stoppers a little to remove them from filter guide.
Take filter stoppers careful not to break them.
Hinge Maintenance cover
Model LGH-F1200RX
5 5
: ............................................. 2 cores
5
Handle Main unit
Lossnay
core
Air filter
Model LGH-F1200RX
5 5
: .......................................... 4 filters
5
Filter guide
Cleaning the parts
1) Air filters
Use a vacuum cleaner to remove light dust. To remove stubborn dirt
wash in a mild solution of detergent and lukewarm water. (under 104˚F
(40˚C))
Air filter
CAUTION
Never wash the filters in very hot water and never wash them by
rubbing them.
Do not dry the filters by exposing them to a flame.
2) Lossnay cores
Use a vacuum cleaner to suck up the dust and dirt on the exposed
Hinge
bracket
surfaces of the Lossnay cores.
Use a soft brush only to clean exposed surface areas.
Do NOT wash in water.
Vacuum cleaner
(with brush attachment)
Corner
CAUTION
Do not use the hard nozzle of the vacuum cleaner. It may damage
the exposed surfaces of the Lossnay cores.
Under no circumstances should the Lossnay cores be washed in
water.
Assembly after maintenance
Bearing in mind the following points, assemble the parts following the
sequence for their removal in reverse.
Arrange the Lossnay core with the air filter side downward.
Note
If "FILTER" and "CLEANING" are indicated or the remote controller,
turn off the indication, after maintenance.
3
Vacuum cleaner
Lossnay core