Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation Instructions
INSTALLING THE REFRIGERATOR (Cont.)
METHOD 2 - INSTALL TO ADJACENT
CABINETS
Attach the Anti-Tip Brackets
1. Pry hole covers from the top of the refrigerator
cabinet to reveal the holes used to install the
anti-tip brackets.
2. Open the upper drawer and leave it open to install
the anti-tip brackets.
3. Remove the anti-tip brackets and screws from the
accessory bag.
4. With the screws provided, fasten an anti-tip bracket
to each side of the top of the cabinet.
Level the dual-drawer refrigerator
Adjustment of the leveling legs under the dual-drawer
refrigerator may be necessary for a proper fit in the
cabinet opening.
1. Adjust the height of the rear of the dual-drawer
by raising or lowering the rear leveling legs, and
then begin to slide the dual-drawer into the under
counter opening.
2. Adjust the front of the dual-drawer, by raising or
lowering the leveling legs, until it fits under the
countertop.
3. Install dual-drawer refrigerator to cabinets.
12
Right Side
Left Side
COMPLETE INSTALLATION
ELECTRICAL SHOCK
WARNING
HAZARD
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the
power cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, fire or
electrical shock.
REINSTALLING/USING
DUAL-DRAWER REFRIGERATOR
AGAIN
IMPORTANT: If the dual-drawer refrigerator has been
time, wait one hour before plugging in the dual-drawer
refrigerator to allow the refrigerant to settle.
1. Clean dual-drawer refrigerator. See Cleaning.
2. Place refrigerator in desired location and level. See
Location Requirements.
ELECTRICAL SHOCK
WARNING
HAZARD
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the
power cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, fire or
electrical shock.
3. Plug into a grounded 3 prong outlet.
49-1000129 Rev. 1
Publicité
Chapitres
Table des Matières
Dépannage
