Zephyr Tempest I AK7000BS Guide D'utilisation, D'entretien Et D'installation page 18

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Charcoal Filter Change Reminder (charcoal filter, if installed)
When your hood is installed as a recirculating unit, it is fitted with a set of charcoal filters to purify exhaust
and fumes from cooking, then re-circulates the air within the home. These charcoal filters are required to
be replaced after every 120 hours of use. The charcoal filters should never be cleaned or placed in a dish
washer.
The filter change reminder function in the microprocessor needs to be switched on. When switched on, the
microprocessor will elapse and count usage time and indicate by a flashing
replacements are needed.
Setting the Filter Change Reminder
When off, hold
for approximately 5 seconds.
The display will change from
(recirculating mode) this indicates that the
C
elapse timer function is switched on and charcoal
filters are used.
Filter Replace Indicator
When the display
starts flashing, the charcoal
C
filters need to be replaced.
Re-setting Function
Once filters are replaced, with hood off, press and
hold
the display will appear; hold for apprimately
5 seconds until
on displays disappears
C
The filter change reminder is now re-set and a new
120 hour elapse cycle is initiated.
(exhaust mode) to
.
16
www.zephyronline.com
when charcoal filter
C
Set Mode
hold 5 sec. display from < - > to < C >
Change FIlters
Set Mode
display < C > flashes
To Reset
hold 5 sec. display from < C > to < >
C
C
C

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Tempest i ak7036bsTempest i ak7042bsTempest i ak7048bs

Table des Matières