Led Indicator Status - Ezviz ez360 Serie Guide De Démarrage Rapide

Setup
Step 1 Power-on
Plug the power cable into the camera, and then plug the power adapter into an outlet as shown
in the figure below. The LED indicator will flash red and blue when the camera is ready for
setup.
Power Interface
Turn on the camera and let it power up. The camera will completely rotate side-to-side
and tilt up-and-down once.
Power Cable

LED Indicator Status

Flashing Blue: The network is properly
connected.
Solid Red: The device is activating.
Slowly Flashing Red: Invalid network connection.
Fastly Flashing Red: MicroSD card or other error
occurred.
Flashing Blue and Red: Camera is ready for Wi-
Fi setup.
1
Power Outlet