Care And Maintenance; Troubleshooting - Kobalt SGY-AIR226 Mode D'emploi

CARE AND MAINTENANCE

ALWAYS DISCONNECT TOOL FROM THE AIR SUPPLY BEFORE
PERFORMING ANY MAINTENANCE ON THE TOOL.
Always make sure the tool is properly lubricated during operation. Proper
lubrication is shown in this instruction manual.
Clean the entire tool with a rag and lubricate the tool after each use. If storing
the tool for an extended period, and run for approximately 30 seconds to
ensure oil has been evenly distributed throughout the tool. Always store tools
in a clean, dry environment away from the reach of children.
Recommended lubricants: air-tool oil or any other high grade turbine oil
containing moisture absorbent, rust inhibitors, metal wetting agents and an
EP (Extreme Pressure) additive. Consult your local retailer for further
assistance in selecting air tool oil best suited for proper lubrication.
STORING:
Tool must be well cleaned and lightly lubricated before storing.
Store tool in a dry, safe place out of the reach of children.

TROUBLESHOOTING

Spindle lock will not pop up:
1. Debris is in between body and spindle lock.
2. Debris is between spindle lock and spindle.
Use a lubricant spray such as WD-40 and spray the
outside of the spindle and the around the spindle
(See Figures 1 and 2). Turn the spindle lock left and right
until spindle lock pops up. Continue to lubricate until
spindle lock works smoothly.
15
1
2
F
F