Kobalt SGY-AIR226 Mode D'emploi page 14

REPLACING CUTTING DISC
5. Place the washer on top of the cutting
disc. By hand, screw the hex nut on by
turning it clockwise. Use wrench (AA) to
tighten (See Figure 5).
DO NOT OVERTIGHTEN
6. Insert the hex key bolt into the spindle,
and using hex key (BB), turn the bolt
counterclockwise to tighten (See Figure 6).
DO NOT OVERTIGHTEN
NOTE This is a left handed bolt.
7. Push down on spindle lock (F) and turn
clockwise to unlock the spindle lock
(See Figure 7).
NOTE If the spindle does not spin freely,
repeat step 7.
5
6
7
14
E
B
AA
BB
D
E
B
F