Kobalt SGY-AIR226 Mode D'emploi page 11

ASSEMBLY INSTRUCTIONS
3. Place 2 - 3 drops of air tool oil
(not included) into the male plug before
each use (See Figure 3).
4. Make sure spindle lock is in the unlocked
position before operating. Push down on
spindle lock (F) and turn clockwise to
unlock the spindle lock. Cutting wheel (B)
should spin freely (See Figure 4).
5. Connect air supply hose to the male plug.
Set the working pressure at 90 PSI for
best tool performance (See Figure 5).
NOTE Working pressure refers to the air line
pressure set to tool when tool is under
working conditions.
3
4
5
11
F