Start-Up; Inserting Batteries; Setting The Remote Control; Operating Other Loewe Devices - Loewe SoundVision ID Mode D'emploi

n n
Loewe SoundVision ID
Instructions for Use

Start-up

Inserting batteries

2
1
Twist the battery compartment lid out in an anti-clockwise direction and
then remove it. Insert a CR2032/DL2032 battery. The plus pole of the
battery must point upwards here. Replace the battery compartment cover
onto the remote control (observe the markings).
➠ Do not insert rechargeable batteries in the battery compartment
of the remote control!
➠ The batteries used must not be exposed to excessive heat such as
sunlight, fi re or similar!

Setting the remote control

The AUDIO and RADIO buttons can be configured to operate certain
Loewe products:
Press the button down that you wish to configure
(AUDIO or RADIO) and then press REC/AUX at the
same time; hold the buttons down for 5 sec.
The LED over the selected button flashes twice.
Input the button combination from the table below
(press the buttons one after another).
Button combination
Red
Green
Blue + yellow
Yellow
Green + blue
Green + yellow
Green + yellow +
blue
Blue
Red + blue
Red + green +
yellow
Red + green +
yellow + blue
Press OK
The LED above the button for the unit flashes twice.
 Default setting
- 32 - - 32 -
Unit
Loewe TV Radio
Loewe Mediacenter
Loewe BluTechVision
Interactive/3D
Loewe AudioVision
Apple Remote
Apple TV
(RADIO)
SoundBox 
(AUDIO)
SoundVision ID 
<AirSpeaker>
MediaVision 3D
Reset all settings

Operating other Loewe devices

Using the remote control for the Loewe SoundBox
Press the button, the LED indicator lights up for about
5 seconds
Using the remote control for a Loewe TV set
Press the button, the LED indicator lights up for about
5 seconds
Every time a button is pressed, the LED indicator lights up for the selected
operating mode to allow you to check (TV – AUDIO – RADIO).
Please refer to the respective operating instructions on how to operate
the individual devices.

Connecting to the mains supply

Make the required cable connections as shown in the section "Connec-
tion" (page 31). Plug the mains plug into the mains socket 220-240V,
50/60 Hz.

Switching on/off

Switch the power switch
SoundVision ID switches on.
Set the Assist Easy remote control for SoundVision ID
mode by pressing the AUDIO button briefly.
Press the on/off button
The unit switches on.
To switch the unit into Quick-start Stand-by Mode,
press the on/off button
switches off. The LED display on the display lights up red.
➠
In Quick-start Stand-by Mode, the switch-on process
is fast, the unit not using much electricity (page
47).
To switch the unit off into Energy Saving Mode, press
the on/off button
announcement "Energy-saving mode is activated" ap-
pears for a few seconds.
The LED light on the display lights up (variant x10 only).
It is possible to switch on via remote control (variant x10
only) and local control.
➠ The power consumption is very low in Energy Saving
Mode (page 47). The switch-on process takes
somewhat longer.
➠ Switch the unit off if you are away for longer periods
first using the on/off button
power switch
and protects the environment.
7 to position I.
1 briefly on the unit.
1 briefly on the unit. The unit
1 on the unit for 5 seconds. The
1 and then move the
7 to position 0. That saves energy