Start-Up And Operation; Switching The Subwoofer On/Off; Settings On The Loewe Tv Set; Settings On The Loewe Auro Preceiver - Loewe Audio Individual Sound Mode D'emploi

Start-up and operation

Before beginning with start-up and operation, make sure that all the cables are
connected correctly.

Switching the subwoofer on/off

You switch the Individual Sound loudspeaker system on in position "I – ON"
with the ON/OFF switch g.
If the subwoofer is connected as described on page 18 to 19, there is no need
to switch the subwoofer on and off separately any more. After switching on the
subwoofer for the À rst time, it is always switched on and off immediately with
the Loewe TV set or the Loewe Auro Preceiver.

Settings on the Loewe TV set

Make the necessary settings on your Loewe Auro Preceiver as described in the
Auro operating manual in the chapter "Initial start-up" / "External devices".

Settings on the Loewe Auro Preceiver

Make the necessary settings on your Loewe Auro Preceiver as described in the
Auro operating manual in the chapter "Initial start-up – setting the loudspeaker
system".

Phase switch/bass intensity

The "Phase" switch i and the "Bass intensity" knob h enable you to optimize
bass reproduction.
We recommend you to proceed as follows:
• If the subwoofer is in the corner of the room, set the bass intensity knob to
"Min".
• If the subwoofer is against a wall, set the bass intensity knob to the center
position.
• If the subwoofer is standing freely in the room, set the bass intensity knob to
"Max".
• Start DVD playback for example and select a title with bass parts.
• Have a second person activate the phase switch whilst you sit and listen.
• Decide for yourself which switch position reproduces the best bass sound.
• Set the bass intensity to suit your taste if necessary.

Setting the crossover frequency

The "Crossover Frequency" knob j gives you the possibility of setting the
limit frequency for bass reproduction between 50 Hz and 250 Hz depending
on which speakers you have connected. The knob should be set to 250 Hz for
Loewe Audio Systems because the crossover frequency is set in the Loewe audio
sources (TV/Auro).

Cover on the subwoofer

After you have made the settings described in "Start-up and operation", replace
the cover on the rear of the subwoofer.
21 -