Maintenance Frequency; Cleaning The Fan; Maintenance Procedure - Master BV 500-15 Série Manuel D'utilisation Et De Maintenance

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

•••10.1.3. Remove the gaskets installed

and do not reuse them. Only use new

and original gaskets (Pic. 12).

•••10.1.4. Spray high pressure water inside

the chamber through the inspection

openings (Pic. 13). When washing,

move the nozzle in various positions

so the water reaches all the slots of the

combustion chamber.

•••10.1.5. Lift the combustion chamber

from the back to empty as much water

as possible from inside the chamber

(this operation must be carried out with

the utmost attention to avoid personal

harm or damaging the heater) (Pic. 14).

•••10.1.6.

Reassemble

performing the sequence of operations

in the opposite order, replacing the

gaskets with original spare parts.

NOTE:

BEFORE

HEATER BACK ON, MAKE SURE AS

MUCH WATER AS POSSIBLE HAS

BEEN ELIMINATED FROM INSIDE THE

COMBUSTION CHAMBER TO AVOID

SERIOUS DAMAGE.

11. PREVENTIVE MAINTENANCE SCHEDULE

WARNING: BEFORE PERFORMING ANY MAINTENANCE OR REPAIRS,

DISCONNECT THE POWER CABLE AND MAKE SURE THAT THE HEATER IS

COMPONENT

Safety

thermostat

Nozzle

Electrical system Yearly check and/or when

Fan

Motor

Fuel pump

Combustion

chamber

the

heater

SWITCHING

THE

MAINTENANCE

FREQUENCY

Yearly check and/or when

required

Replace yearly and/or when

required

Yearly cleaning and/or when

required

Yearly check and/or when

required

Yearly check and/or when

required

Yearly check and/or when

required

►►10.2. CLEANING THE FAN:

Use compressed air for routine cleaning

of the fan, blowing the air through the rear

grille.

►►10.3. CLEANING THE BURNER:

IMPORTANT:

be carried out by contacting the

authorised technical support centre.

Read and understand the specific manual

to clean the burner.

COLD.