Getting Started - Bushnell Night Vision 26-0400 Manuel D'instructions

GETTING STARTED

Installing Batteries
This device operates on two AA batteries. To install, unscrew the
battery compartment cover located on the bottom of the unit.
Insert the batteries into the battery compartment so that the (+)
and negative (-) terminals of the batteries match the markings
inside the compartment. Replace the battery cover carefully – do
not over tighten.
Use and Testing
This device operates on two AA batteries. Make sure they have
been installed according to the instructions above.
If you wish to test your night vision device in a lighted area,
be sure the objective lens cap is covering the objective lens
prior to pressing the "POWER" button. The objective lens cap
has a pinhole opening to admit a small amount of light for
testing purposes.
If testing or using the device in the dark, remove the objective
lens cap and activate the device by pushing the "ON" button.
To focus, select an object at the approximate distance for the area
that you intend to view. Set the adjusting mark on top of the
front (objective) lenses against the letter "N" on the word
"Normal". Adjust each eyepiece diopter setting until the image
is in focus. After your initial diopter setting, the front (objective)
lenses are now utilized for focusing: adjust the front lenses
clockwise when you need to focus on closer objects, counter
clockwise for more distant objects. If you are unable to focus on
very close objects, the eyepieces may then be used for micro
adjustments only.
5
Your Night Vision device offers a Built-In Infrare d
Illuminator. This allows you to see in complete darkness
where no ambient light source, such as moonlight, is
available. If the subject is to be viewed in a completely
dark area, activate the infrared illuminator by pressing
the Infrared Illuminator button located next to the
"POWER" button. This device can be mounted on any
tripod with a 1/4" tripod socket.
6