EIBENSTOCK ESD 162 Notice Originale page 21

Attention!
When you use or sharpen the machine, it might heat up enormously.
You could burn your hands or get cut or ripped by the segments.
Therefore, always use protective gloves when changing the drill bit.
The drilling spindle has a right-hand thread.
To ease screwing on and off, always use a SW 32 open-end wrench at the
drilling spindle. Never use a hammer, because this may damage both the
drill bit and the tool. Some water-resistant grease on the drilling spindle
threat or a copper ring between spindle and drill bit will simplify removal of
the drill bit.
After Drilling
When you have finished drilling:
Pull the drill bit out of the hole.

Turn the motor off.

Removal of the core when it sticks in the drill bit:
Separate the drill bit from the motor (if possible).

Put the drill bit in a vertical position.

Knock carefully on the pipe by using a wooden hammer shank till the

drilling core slips out. Never throw the drill bit against a wall by force
or set about it with tools, such as hammer or jaw wrench. Otherwise,
the pipe could go out of shape and neither the drilling core can be
extracted nor the drill bit is reusable.
Removal of the core by blind holes:
Break off the core with a cotter or lever, or in pieces. Lift the core out with
appropriate tongs or drill a hole with a dowel in the core, screw an eyebolt
in and pull the core out.
The drill rig does not belong to the supply.
For this purpose, please refer to the drill rig's operating instructions.
Overload Protection
To protect the user, motor and drill bit, the ESD 162 is equipped with a
mechanical, electrical and thermal overload protection.
Mechanical: In the event of a sudden jamming of the drill bit, the
machine's kickback is limited to a reaction torque
controllable by the operator by means of a slip clutch.
Changing Drill Bits
Rig Drilling
20