Troubleshooting - MAXDATA A Guide Utilisateur Concis


Wireless Device
Operation Aboard
Aircraft
The use of any portable
electronic transmission
devices aboard aircraft is
usually prohibited. Make
sure the wireless mod-
ules are OFF if you are
using the computer
aboard aircraft.
Use the key combina-
tions to toggle power to
the 3.75G/HSPA/WLAN/
Bluetooth modules, and
check the LED indicator/
visual indicator to see if
the modules are powered
on or not (see Table 2 on
page 4 and Table 4 on
page 6).
10

Troubleshooting

Problem
The Wireless LAN/ The modules are off. Check the LED indicator
Bluetooth/3.75G/ indicator to see if the WLAN/Bluetooth/3.75G/HSPA module is on or off
HSPA modules cannot (see
be detected. off, then press the Fn + F11 (WLAN), Fn + F12 (Bluetooth) or Fn +
(3.75G/HSPA) in order to enable the modules (see
The Wireless LAN The WLAN module is turned off in the Windows Mobility Center. The
indicators computer's wireless function keys will not function properly if Wireless is
show turned OFF in the Windows Mobility Center control panel. Make sure
that the WLAN module that Wireless is ON in the Windows Mobility Center to ensure proper
is powered on, function key behavior.
however the module
does not connect.
The Bluetooth module The Bluetooth module's default state will be off after resuming from the
is off after resuming Sleep power-saving state. Use the key combination (Fn + F12) to power
from Sleep. on the Bluetooth module after the computer resumes from Sleep.
The captured video Note that capturing high resolution video files requires a substantial
files from the PC amount of disk space for each file.
Camera are taking up
Note that the Windows system requires a minimum of 15GB of free
too much disk space.
space on the C: drive system partition. It is recommended that you save
the capture video file to a location other than the C:drive, limit the file
size of the captured video or reduce video resolution (Options > Video
Capture Pin... > Output Size).
Possible Cause - Solution
Table 2 on page 4 and Table 4 on page
and/or function key
6). If the LED indicator is
Table 4 on page 6).