¡ Multi-blender attachment
7.10 Drive cover
Remove the protective cover to use
accessories on drive 2 or 3.
Removing drive cover
Press down the protective cover
1.
for drive 2 at the marking
remove.
→ Fig.
22
Pull up the protective cover for
2.
drive 3 and remove.
→ Fig.
23
Fitting drive cover
Align the protective cover for the
1.
drive 2 with the marking
wards the back, position and press
in place firmly.
→ Fig.
24
Position the protective cover for
2.
the drive 3 and press in place
firmly.
→ Fig.
25
Markings
and
up.
Note: Always close unused drives
with the protective covers.
Scales
8 Scales
Your appliance is equipped with a set
Scales
of scales. You can weigh ingredients
individually.
The base unit has 4 weight sensors
in its feet.
The following factors can falsify the
measuring result:
¡ Feet not standing on the work sur-
face properly
¡ Work surface vibrating
¡ Objects underneath the base unit
¡ Ingredient quantities less than 5 g
or 0.01 lb
and
to-
must match
¡ Base unit slipped
¡ Base unit touched
¡ Objects on the base unit
8.1 Display values of scales
Observe the following values when
using the scales.
Display unit in grams
Display range
Display steps
Display unit in pounds
Display range
Display steps
Tip: You can change the display
units of the scales at any time.
→ "Changing the display units of the
scales", Page 44
8.2 Weighing ingredients
Requirements
¡ The bowl is inserted or an access-
ory is fitted.
¡ The rotary switch is set to
Press
and do not touch the ap-
1.
pliance again.
a The scales will be calibrated.
a The display shows "- - - -".
Wait for calibration to finish.
2.
a The display shows "0 g" or
"0.00 lb".
Add the required ingredient.
3.
a The display shows the weight.
To weigh further ingredients, select
4.
one of the following options:
Add further ingredients and read
‒
off the total weight.
Press
and wait until the dis-
‒
play shows "0 g" or "0.00 lb".
Scales en
-990 g to 5000 g
5 g
-2.20 lb to
11.00 lb
0.01 lb
.
43