Lanaform Active Mass Manuel D'instruction page 4

• Do not use this unit in a closed room where aerosol products are used by employees on a regular basis, or in a room
EN
where oxygen is administered.
• Do not use the device under a blanket or pillow. This can cause overheating which may lead to a fire, electric shock or
injury to persons.
• This unit is not intended to be used by people, including children, whose physical, sensorial or mental skills are
impaired, or by people who do not have the proper experience or knowledge, except if they are supervised or given prior
instructions about the usage of this unit by an intermediary responsible for their security. Children should be supervised
at all times to make sure that they do not play with the unit.
• Keep this device out of reach of children.
• Use the «ACTIVE MASS» massage device only for its intended use as described in this manual.
FUNCTIONS AND USE:
«ACTIVE MASS» has a standby mode and a working mode. In the standby mode, you can preset the duration of the
massage. In the working mode, you can adjust the massage intensity.
"Standby" Mode
When you plug the "ACTIVE MASS" in, it goes directly into standby. The default duration of the massage is 10 minutes. You
can adjust the duration from 1 to 20 minutes by successively pressing the «+» and «-» buttons.
"Run" Mode
When you press the «RUN» button, "ACTIVE MASS" immediately begins running. The default intensity of the massage is
«3». You can adjust it by pressing the «+» and «-» buttons. The intensity of the massage varies from 1 to 5.
"Light" Mode
In any mode, you can always press the «LIGHT» button to turn the light signals on or off.
INSTRUCTIONS FOR USE:
1. Insert the plug into the socket. The device goes into standby mode.
2. Set the massage duration by pressing the «+» and «-» buttons.
3. Then press the «RUN» button to start.
4. Set the massage intensity by pressing the «+» and «-» buttons.
5. Press the «RUN» button if you want to interrupt the remaining massage time.
6. When the massage time has elapsed, the device automatically returns to standby mode.
7. Remember to unplug the device once the massage is finished so that the engine can cool down before using the device
again.
MAINTENANCE:
1. STORAGE:
• Store the massage device in its box in a safe, dry and cool place.
• Do not bring the device into contact with sharp objects that could damage the outer surface.
• Do not wind the power cable around the device. (This can cause wear and rupture of the cable).
4