Changing The Filter - Beurer IH25 Mode D'emploi

Note:
The nebuliser can be used in two differ-
ent ways:
• With the cap [12] closed, you receive
a reduced nebulisation of approx.
0.081 ml/min.
• With the cap [12] open, you receive a
standard nebulisation of approx.
0.249 ml/min.
Note:
The nose attachment [9] must only be
used if the cap [12] on the nebuliser [11]
is closed.
• End of inhalation: If the spray is only output sporadically or if the noise changes
5
during inhalation, you can end the treatment.
• After treatment, turn off the inhaler at the switch [4] and disconnect it from the
mains.
• Once treatment is complete, place the nebuliser [11] back in its holder.
6 Clean the device
See section "Cleaning and maintenance" on page 28 and "Disinfecting the nebuliser
and accessories" on page 26.
7

Changing the filter

Check the filter at regular intervals (e.g. after every 10th use). If the filter is very contami-
nated or blocked, replace the used filter. If the filter has become wet, it must also be re-
placed with a new one.
CAUTION:
• Do not try to clean and re-use the used filter!
• Only use original filters supplied by the manufacturer. Otherwise, your nebu-
liser may become damaged or effective therapy can no longer be guaranteed.
To replace the filter, proceed as follows:
CAUTION:
• First switch off the unit and unplug it.
• Let the unit cool off.
12
Note:
The performance specifications may va-
ry for medicines provided in the form of
a suspension or which are highly vis-
cous. In these cases, more information
can be obtained from the supplier of the
medicine.
25