4� Clean the silicone attachment, nasal secretion container, rubber
seal and valve with hot water and some mild soap� Do not use
any harsh cleaning products� To disinfect the silicone attachment
and the nasal secretion container, place them in boiling water
for 3 to 5 minutes� Contact between the parts and the hot base
of the pan should be avoided� Place the individual components
subsequent on a dry, clean and absorbent surface and allow to
dry completely (for at least 4 hours)�
5� Clean the head unit exclusively with water� Do not use soap or
chemical cleaners, as these can clog the tip of the head unit�
6� Only clean the main device with a clean, dry cloth� Do not use any
corrosive cleaning products, solutions or benzenes� The device
must not be cleaned with water or submerged in water�
7� Using a dirty or damaged valve can decrease the suction pressu-
re of the nasal aspirator� The valve must be replaced as soon as
you notice it is dirty or damaged� Additionally, the valve must be
completely dry after cleaning in order for the device to function�
The suction power is impaired/non-existent even if there is a small
amount of residual moisture remaining�
8� Dry all parts carefully using a soft cloth� Do not reassemble the
parts until they are completely dry� Store the device away from
sunlight, dust and moisture�
9. Disposal
Disposal of the device
For environmental reasons, do not dispose of the device in the
household waste at the end of its useful
life� Dispose of the device at a suitable local collection or recycling
point in your country� Dispose of the device in accordance
with EC Directive – WEEE (Waste Electrical and Electronic
Equipment)� If you have any questions, please contact the
local authorities responsible for waste disposal�
Disposal of the batteries
• The empty, completely flat batteries must be disposed of through
specially designated collection boxes, recycling points or electron-
ics retailers� You are legally required to dispose of the batteries�
28