Getting Started - Ribimex TIMEO Manuel D'instructions Et D'utilisation

respiratory system.
• Only use the battery pack provided with the tool. The use of other types of batteries may
increases the risk of electric shock, personal injury and damage.
• The batteries are not replaceable. If the batteries become defective or damaged, do not use
the lamp and do not attempt to recharge the batteries. Discard the product. The battery pack
terminals may be short-circuited causing damage to the battery or burns or a fire.
IV. GETTING STARTED
4.1- Unpacking
• Remove the product from carton and discard all packaging properly.
• Check if the product and accessories (if any) are intact.
4.2- Content
PRLUMSOL4/M
• Lamp head x 1
• Lamp head support assemby x 1
• Remote control x 1
• Wall base x 1
• Screw x 2
• Anchor x 2
4.3- Assembly
WARNING!
Before assembly or intervention on product, ensure that switch is set on the "OFF"
position.
ATTENTION!
The lamp should be permanently mounted on a sturdy support where the solar
panel can be easily reached by direct sunlight.
①
A) Switch ON the power.
B) Insert lamp head into the support tube.
②
Take off the wall base from the lamp
assembly, use it as the template, then
mark the drilling position with marker.
Page 11 / 21