ARENDO 303062 Mode D'emploi page 11

6. Brief operation
The device is designed only for brief periods of operation. You can use the
blender continuously for about 2-3 minutes. After this time, you must allow the
motor to cool down for approx. 5 minutes. Do not exceed the operating time in
any case!
7. Commissioning
7.1 Blender jar
Remove the protective cover from the blade unit. Place the blade unit in the blend-
er jar on the middle jar axle so that it is firmly secured. Subsequently, add the de-
sired ingredients in the blender jar and close the jar lid properly. Put the base unit
on the jar lid. Then connect the power plug of the device into a properly installed
power socket.
7.2 Smoothie jar
Open the smoothie jar and fill it with the required ingredients. It is advisable to
start by adding liquids. You can then add the ingredients (e.g., fruits) and finally
add yoghurt or ice cream.
Now fix the blade unit onto the blender jar 2. Then connect the power plug of the
device into a properly installed power socket.
Place the blender jar with the blade unit onto the base unit. Ensure that the
smoothie jar is properly placed on the base station.
7.3 Operation
A switch is located at the front of the device. The blender is switched on as long as
you press the switch. The prescribed operating time (short time operation) should
be observed. If you wish to blend in pulsating steps, press the on/off button repeat-
edly. This allows you to vary even the pulsing interval. Then remove the blender
jar from the base unit.
Note: The device is designed only for brief periods of operation. You must allow
the device to cool down sufficiently after 2-3 minutes of continuous operation
before you start operating it again!
11
English