Additional Safety Rules - Panasonic EY3640 Instructions D'utilisation

EN
WARNING
• Do not use other than the Panasonic bat-
tery packs that are designed for use with
this rechargeable tool.
• Panasonic is not responsible for any
damage or accident caused by the use of
recycled or counterfeit battery pack.
• Do not dispose of the battery pack in a
fi re, or expose it to excessive heat.
• Do not allow metal objects to touch the
battery pack terminals.
• Do not carry or store the battery pack
in the same container as nails or similar
metal objects.
• Do not charge the battery pack in a
high-temperature location, such as next
to a fi re or in direct sunlight. Otherwise,
the battery may overheat, catch fi re, or
explode.
• After removing the battery pack from the
tool or the charger, always reattach the
pack cover. Otherwise, the battery con-
tacts could be shorted, leading to a risk
of fi re.
• When the Battery Pack Has Deteriorated,
Replace It with a New One. Continued
use of a damaged battery pack may result
in heat generation, ignition or battery
rupture.
• To prevent leakage, overheating, smoke
generation, fi re, and rupturing from
occurring, follow these instructions when
handling our rechargeable power tools
(tool main body/battery pack/charger).
- Do not allow material cuttings or dust to
fall onto the battery pack.
- Before storing, remove any material
cuttings and dust from the battery pack,
fi t red plastic "terminal cover", then place
separately from metal objects (screws,
nails, etc.) in tool case.
Damage caused by loose objects in the
case will not be covered by warranty.
• Do not handle the rechargeable power
tools in the following way.
(There is a hazard of smoke generation,
fi re, and rupturing)
- Use or leave in places exposed to rain
or moisture
- Use submerging in water
V .
ADDITIONAL
SAFETY RULES
1) Stop using the tool if you notice some-
thing abnormal.
2) During charging, the charger may become
slightly warm. This is normal. Do NOT
charge the battery for a long period.
3) The appliance is not intended for use by
young children or infi rm persons without
supervision.
4) Young children should be supervised
to ensure that they do not play with the
appliance.
Preparing the sealing gun
For preparation of sealing compound, such
as cutting the opening to the desired diam-
eter, follow the instructions of the cartridge /
sausage pack.
VI.
ASSEMBLY
NOTE:
When attaching or removing a sealing com-
pound or an accessory or when storing the
main unit, place the application speed control
(See the page.2 (K)) in the lock position and
remove battery pack from the main unit.
Inserting the sealing
compound into the gun
For use with cartridges
1) Cut off the tip of nozzle at a point suitable
for the job.
[Fig.1]
2) Pull the rack all the way to rear.
[Fig.2]
3) Unscrew the tube holder from the hous-
ing, and remove the sausage pack adapt-
er from the rack.
[Fig.3]
4) Install the tube holder on the housing,
remove the front cap from the tube holder,
and insert the cartridge.
[Fig.4]
- 10 -