Kimex 164-6540 Manuel D'utilisation page 137

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ADCCAL
SET3DMODE
SET2DONLY
SETVIRTUAL3D
PATTERN
GETPATTERN
BRIGHTNESSUP
BRIGHTNESSDOWN
CONTRASTUP
CONTRASTDOWN
Command
GETSWPROFILE
VERSION
PRINTALLPROFILE
PRINTHWPROFILE
Start ADC auto
calibration.
Set 3D mode values
(values are off, auto,
side by side, top
bottom and game)
Set 2D values.
Set virtual 3d values.
Set panel screen to
selected pattern.
Get selected pattern
of the panel screen
Inrease Brightness
Level by 1 step
Decrease Brightness
Level by 1 step
Inrease Contrast Level
by 1 step
Decrease Contrast
Level by 1 step
PROFILE COMMANDS
Description
Gets sw profile version
Prints hw, sw and dev
profile values.
Prints hw profile values.
English - 47 -
int n (0 = SCART-RGB, 1 =
YPbPr, 2 = PC/VGA)
int n (n = off, auto, side by
side, top bottom, game)
int n (0 = off, 1 = left, 2 =
right)
int n (0 = off, 1 = low, 2 =
medium, 3 = high)
str-int n (n = WHITE, RED,
GREEN, BLUE, MAGENTA,
CYAN, YELLOW, GRAY,
BLACK, CLEAR, r-g-b) [r,
g, b are bytes representing
color component values]
no parameter
no parameter
no parameter
no parameter
no parameter
Parameter
no parameter
no parameter
no parameter
#*ADC Auto Calibration completed
R_Gain= ...
G_Gain= ...
B_Gain= ...
R_Offset= ...
G_Offset= ...
B_Offset= ...
#*set3DMode() set to n
or
#*Incorrect 3d mode parameter
entered
set2DOnly() set to n
or
Incorrect 2d only mode paramater
entered
setVirtual3D() set to n
or
Incorrect virtual 3d mode
paramater entered
#*set pattern to n
The pattern is ...
Picture brightness value is set to ...
or
Picture brightness value is at max
value.
You can not increase brightness
level further.
Picture brightness value is set to ...
or
Picture brightness value is at min
value.
You can not decrease brightness
level further.
Picture contrast value is set to ...
or
Picture contrast value is at max
value. You can not increase
contrast level further.
Picture contrast value is set to ...
or
Picture contrast value is at min
value. You can not decrease
contrast level further.
Return
#*sw profile version is ...
or
#*sw profile version is not defined
...
...

Publicité

Table des Matières
loading

Table des Matières