Connectivity - Kimex 164-6540 Manuel D'utilisation

Connectivity

To configure wired or wireless settings you should
access the Network menu in the Settings menu.
Wired Connectivity
To Connect to a Wired Network
• You must have a modem/router connected to an
active broadband connection.
• There is a LAN port at the bottom of the rear side of
your Display. Connect your Display to your modem/
router via this LAN port using an Ethernet cable.
3
Broadband ISP connection
1
LAN (Ethernet) cable
2
LAN input on the bottom of the rear side of the
3
Display
Configuring Wired Device Settings
Network Type
Set the Network Type as Wired Device if you are
connecting via an Ethernet cable.
Internet Speed Test
Highlight Internet Speed Test and press the OK
button. Display will check the internet connection
bandwidth and display the result when complete.
Advanced Settings
Highlight Advanced Settings and press the OK but-
ton. On the next screen you can change the IP and
DNS settings of the Display. Highlight the desired one
and press Left or Right button to change the setting
from Automatic to Manual. Now you can enter the
Manual IP and / or Manual DNS values. Select the
related item in the drop down menu and enter the
new values using the numeric buttons on the remo-
te. Highlight Save and press the OK button to save
settings when complete.
Other Information
You can also enable or disable Wake On feature using
the related option. The status of the connection will
be displayed as Connected or Not Connected and
1
2
the current IP and MAC addresses, if a connection is
established.
Wireless Access Point (Optional)
If the network type is set as Wired Device access point
feature will be available. Highlight Access Point option
and press OK. Access Point, SSID, Security Type and
Password options will be available.
Access Point: Start or stop access point functionality.
The function of this option will change according to the
current status.
SSID: Set the name of the accesspoint.
Security Type: Secure your network using WPA2 PSK.
You can also set this option as None. In that case no
password will be required to connect to the access point.
This option can be set only if the access point feature
is not activated.
Password: Define a password for the access point.
This option will be available if the Security Type option
is set as WPA2 PSK and can be set only if the access
point feature is not activated.
Wireless Connectivity
To Connect to a Wireless Network
• You must have a wireless modem/router connected
to an active broadband connection.
Broadband ISP connection
1
• A Wireless-N router (IEEE 802.11a/b/g/n) with
simultaneous 2.4 and 5 GHz bands is designed
to increase bandwidth. These are optimized for
smoother and faster HD video streaming, file
transfers and wireless gaming.
• The frequency and channel differ depending on
the area.
• The transmission speed differs depending on the
distance and number of obstructions between the
transmission products, the configuration of these
products, the radio wave conditions, the line traffic
and the products that you use. The transmission may
also be cut off or may get disconnected depending
on the radio wave conditions, DECT phones or any
English - 23 -
1