Dismounting The Unit; For Windows - Buffalo HD-LBU3 Manuel D'utilisation

continue.
You may hear some noise while the unit is working, especially while it's booting or being accessed. This is normal.
Disconnect this drive before reinstalling Mac OS.
Do not boot your operating system from this unit.
The first time you connect this unit, it may take about 20 seconds before the power/access LED turns on.
If you use this unit with multiple partitions, format each partition before use.
If your Windows computer will not boot while this unit is connected, then connect the unit to your computer after
rebooting Windows. Also, refer to your computer's manual to change the BIOS setting to boot from an internal
hard drive if you want to turn your computer on or off while this unit is connected.
Some computers may display a delayed write when they return from an energy-saving state. If this happens,
unplug the unit before putting your computer into the energy-saving mode.
This drive may become hot during use.
This.unit.is.designed.to.release.heat.through.its.case...The.surface.of.the.case.may.become.quite.hot.in.normal.use...Even.
when.the.unit.is.off,.the.case.may.still.be.warm.from.standby.current.
If the power/access LED does not turn off when you turn off your computer, unplug the USB cable from the drive.
Some computers do not support power saving mode.
Before using this unit with a Mac, reformat it with Mac OS extended using the disk utility in Mac OS.

Dismounting the Unit

Unplugging.the.unit.incorrectly.can.corrupt.data..Please.be.careful!..If.your.computer.is.turned.off,.then.it.is.always.safe.
to.unplug.the.unit...If.your.computer.is.turned.on,.please.follow.the.procedure.below.to.unplug.the.unit.

For Windows

Note:
For.Windows.8,.switch.to.desktop.mode.
1
Click.the.icon. .or.
2
When.the.menu.opens,.click.the.device.name.
.in.the.system.tray.
24