Troubleshooting - GreenWorks Commercial GL 900 Manuel Du Propriétaire

TROUBLESHOOTING

Always disconnect the battery from the power tool before performing any maintenance work.
PROBLEM
Power tool does not start after
switch-on.
Power tool shuts down during
operation.
CAUSE
No electrical contact between power
tool and battery.
Battery has low charge
(beep once per 10 sec).
Battery too hot / too cold
(LED indicate HI or LO & beep
continuously).
Malfunction in battery
(LED will indicates Malfunction code
such as E0,E1,E2,E3,E4,E5,E6).
E l e c t r o m a g n e t i c p r o b l e m o r
malfunction in machine.
Moisture in power tool and/or battery. Allow power tool battery to dry.
Battery or machine's electronics are
too hot.
E l e c t r i c a l o r e l e c t r o m a g n e t i c
malfunction.
Malfunction in battery
(LED will indicates Malfunction code
such as E0,E1,E2,E3,E4,E5,E6).
18 18
SOLUTION
Remove adapter, check contacts
and refit adapter.
Charge the battery.
Allow battery to cool down to
temperatures of about 10-40°C
(50-104°F). Allow battery to warm
up slowly.
Disconnect battery from power
t o o l , t a k e i t o f f y o u r b a c k ,
observe battery and contact your
GREENWORKS servicing dealer
immediately.
If the battery emits fumes, heats
up, smells, makes noises or
shows signs of deformation,
disconnect it from the power tool,
take it off your back, put it down
and immediately move a safe
distance away. Keep children
and animals away from the work
area. Keep battery away from
combustible materials.
Take the adapter out of the power
tool and refit it. Switch on the
power tool – if it still doesn't work,
the power tool has a malfunction
a n d m u s t b e c h e c k e d b y a
GREENWORKS servicing dealer.
Take the adapter out of the power
tool; allow the battery and power
tool to cool down.
Remove the adapter and refit it
again.
Disconnect battery from power
t o o l , t a k e i t o f f y o u r b a c k ,
observe battery and contact your
GREENWORKS servicing dealer
immediately.
If the battery emits fumes, heats
up, smells, makes noises or
shows signs of deformation,
disconnect it from the power tool,
take it off your back, put it down
and immediately move a safe
distance away. Keep children
and animals away from the work
area. Keep battery away from
combustible materials.