After Finishing Work; Assembling The Battery; Connecting The Adapter - GreenWorks Commercial GL 900 Manuel Du Propriétaire

OPERATION
Never work with the battery in trees, on roofs or on a ladder or other areas with poor footing.
Make sure the cable cannot become entangled or snag on objects – position and secure the
cable carefully before starting work.
If the battery is subjected to unusually high loads for which it was not designed (e.g. heavy
impact or a fall), always check that it is in good condition before continuing work. Do not continue
operating the battery if it is damaged. In case of doubt, contact your GREENWORKS servicing
dealer.

After Finishing Work

Clean the battery – see "Cleaning the Battery".

ASSEMBLING THE BATTERY

Connecting the Adapter

1. Insert the plug (1) of one side into the socket (2) of the battery – line up the lugs on the plug
with the slots in the socket.
2. Push the plug into the socket until it stops, (3) then turn it clockwise until the plug's latch (3)
engages audibly.
3. Fit cable (4) into the cable duct (5) and wind through the housing – see also "Positioning the
Cable".
2
3
5
6
1
4
7
6