GreenWorks Commercial GL 900 Manuel Du Propriétaire page 12

OPERATION
LED ON BATTERY
The LEDs show the battery's capacity & any problem with the battery or the power tool being
used.
1
Press button (1) to activate the LEDs – the display goes off automatically after 5 seconds.
The acoustic signal must sound briefly when the button is pressed (to confirm function) – see
also "Acoustic Signal".
During Charging Process
The words showing the current battery capacity will be blinking.
During Operation
LED will indicate the battery capacity.
If the LED glow continuously / flash
When the pack goes wrong, it will show different fault codes – see "Troubleshooting".
E0 – BMS fault
E1 – Over-current (discharging)/(charging)
E2 – Communication fault (with charger or external tools)
E3 – Over-voltage of cell
E4 – Low-voltage of cell
E5 – Bad consistency of cell
E6 – External tools abstract electricity
HI – Over temperature of battery
Lo – Low temperature of battery
12