Important Information:
®
The Legend
automatic pool cleaner comes ready to connect into a female threaded 1-1/2" (38mm) line,
dedicated to our Universal Booster Pump. Also, if you have a chlorinator, solar system or other air
inducing equipment, please contact our Technical Support Department at 1-800-831-7133 [USA] or
{Herentals – Belgium +32 (0) 14.25.99.11}, before you install the Legend
The following are important facts to remember before installing and operating the Legend
1. Always disconnect the Legend
2. After cleaning or back washing, let the filtration system run for at least five minutes before
reconnecting the Legend
3. New plumbing lines should be flushed out before installing the Legend
4. The Legend
®
should not be used to remove plaster dust in new pools.
5. Always remove the Legend
6. Always handle the Legend
7. Always pick up the Legend
8. Unless checking the wheel RPM, do not handle the Legend
9. Always remove the Legend
water that is unsafe for swimming is unsafe for the Legend
10. Carefully cut the feed hose following the instructions on
By following these simple guidelines, you can help protect against injury and prolong the life
®
of your Legend
.
®
Before the Legend
located on your warranty card and on the back of the Legend
this number when you contact our Technical Support Department.
SERIAL #
®
from the pool wall when cleaning or back washing the pool filter.
®
.
®
before swimmers enter the pool.
®
with care. Do not let children or pets play with the unit: it is not a toy.
®
by the handle, especially when lifting the unit out of the water.
®
from the pool before chemical shock treatments. As a rule, any pool
is installed, please take a moment to record the serial number. This number is
__________________________________
LL505G
LL505GG
®
Page
®
near the rear jet. You will be asked for
®
. (See diagram on
®
.
®
while it is operating.
.
9.
LEGEND
®
Page
8.)
®
.
5
[English]
INSTALLATION MANUAL