Publicité
17
DRILL THE OTHER HOLES.
19
SET THE RIVETS IN PLACE.
21
MEASURE AND CUT THE DITCH MOLDING.
Measure the spaces between the
brackets along the contour of the roof.
Cut the ditch molding with tin snips or
other means to fit into the spaces.
Instruction #1035971C - Page 5 of 14
• Remove the rivet and the
bracket.
• Drill pilot holes with the 1/8"
drill bit where you made the
marks.
• Then use the 3/16" drill bit to
drill the holes to 3/16".
• Repeat the process on the
other side of the vehicle.
• Carefully blow or brush aside
the swarf (metal debris)
on each side to prevent
scratching the paint.
20
6X
6X
APPLY SILICON
18
AROUND THE HOLES.
Apply an even
ring of silicon
around each hole.
4X
4X
INSTALL THE RIVETS.
Use a rivet tool
to flare the
rivets. Start
with the center
rivet then flare
the other rivets.
6X
6X
6X
6X
Publicité
