Information For Installation - Sentiotec Vitae DIR-350-R Instructions De Montage Et Mode D'emploi

2. Information for installation

CAUTION: all packaging components must be removed before commissioning
The infrared radiator is also suitable for installation on the cabin ceiling. Ensure that the reverse of the
radiator is not covered and that the generated heat can escape!
If the infrared radiator is installed in the back region, a suitable protective measure must be implemented to
ensure that the protective grille or front glass panel cannot be inadvertently depressed.
Ensure compliance with minimum distances.
The glass plate of the radiator can become very hot. Ensure by means of a suitable protective measure
that adequate contact protection exists.
Install vertically in such a way that the connection box faces upwards!
An optional screen is available for installation in a spray water-protected manner in accordance with IPX4
VIT-BL-L stainless steel screen for IR radiators (500W/750W)
VIT-BL-S stainless steel screen for IR radiators (350W).
A minimum distance of 150 mm must be complied with between the radiators.
Radiator types DIR-750R and WIR-750R must only be installed in the cabin ceiling at a height which is not
easily reachable (>1.8m).
There must be at least 150mm of free, well ventilated space above the radiator.
This minimum distance also applies if the DIR-350R / WIR-350R / DIR-500R / WIR-500R radiator is installed
directly into the cabin ceiling.
The minimum distance between two radiators located opposite one another must be 900mm.
If a radiator is installed in the field of vision, a minimum distance of 600mm must be complied with between
the face of the user and the radiator.
WE DO IT FIRST.
Instructions for installation and use – only for experts P. 4/10