Removing the oven doors
CAUTION
•
The door is very heavy. Be careful when removing and lifting the door.
•
Do not lift the door by the handle.
Use two hands to remove the oven door. For double ovens, repeat the process
for each door.
Wire Harness
A.
NV51M9770DS_AA_DG68-01001A-00_EN+MES+CFR.indb 55
1.
Prior to removing the oven door,
prepare a surface where you will place
it. This surface should be flat and
covered with a soft blanket. You can
also use the corner posts from your
packaging material.
2.
For the upper oven door (Skip this
A
step for the lower oven door): Remove
the rubber cap, and then disconnect
the LED light's Wire Harness from the
bottom right of the door.
NOTE
If you are removing the upper door, you
must open the lower door to access the wire
harness.
3.
4.
A
B
A.
Oven door hinge lock in
locked position
B.
Oven door hinge lock in
unlocked position
5.
6.
7.
Open the oven door.
Locate the oven door hinge locks in
both corners of the oven door, and then
rotate the hinge locks toward the oven
door to the unlocked position. If the
door hinge lock is not rotated fully (see
illustration B on the left for an example
of full rotation), you will not be able to
remove the door properly.
Partially close the door to engage the
door latch locks. The door will stop at
this point.
Using two hands, grasp the edges of
the oven door. Lift and pull the oven
door toward you and remove. You may
need to gently shift the door from side
to side as you pull.
For the lower oven door (Skip this step
for the upper oven door) : Remove
the rubber cap, and then disconnect
the LED light's Wire Harness from the
bottom right of the door.
English 55
2017-07-26
4:07:38