Krups FME1 Mode D'emploi page 8

Features of Programmable Timer Models Features of Programmable Timer Models
If your model has a programmable clock/timer the following features are included:
. Auto On - Allows you to set the daily start time of the brew cycle.
. Auto Off - Allows you to set the length of time the coffee machine will stay on. It can be set
from 1 to 5 hours for units with glass carafes and is set to 20 minutes for units with thermal
carafes.
. Audible Signal - Beeps when the coffee is done brewing. This can be turned off or on.
. 1 - 3 Cup Flavor Setting :
(10)
10
AM
PM
. Electronic Limescale Detection - Indicates when the coffee machine needs to be descaled.
. Empty Water Reservoir - Indicates when the water reservoir has not been fi lled and auto-
matically shuts off the coffee machine.
Programming Your Coffee Machine Programming Your Coffee Machine
• Plug in your appliance: the display will light up briefl y in blue, blink "8888" and then remain
fi xed.
• Press the O/I button if you wish to make coffee without using the programmable mode.
• The display will light up in blue and alternately show "ON" and the current time.
• Press the O/I button to shut off the coffee machine. The display will no longer be lit.
Setting and Adjusting the Clock
• The machine must be "off".
• Press and hold the prog button (o) for 3 seconds: the hours will blink "88 _ _".
• Adjust the hours in steps by pressing the h/min button (n).
• Press the prog button : the minutes will blink" XX 88".
• Adjust the minutes in steps by pressing the h/min button.
• Confi rm the setting by pressing the prog button.
Setting Auto On
This programs the coffee machine to start automatically at the set time each day.
• Press the prog button (o) briefl y : the display will blink "prog" for about 1 second, fol-
lowed by "8888".
• Press the prog button briefl y: the hours will blink "88 _ _".
• Adjust the hours in steps by pressing the h/min button (n).
• Press the prog button briefl y: the minutes will blink "XX 88".
• Adjust the minutes in steps by pressing the h/min button .
• Confi rm the setting by pressing the prog button briefl y:
To extract the full fl avor or the grinds from smaller quantities.
Exercise caution with hot water and steam.
9