Campbell Hausfeld CL252100AV Mode D'emploi page 3

uctions
n (Continued)
Do not use
hoses or fi ttings
ed or deteriorated.
Never carry a tool
by the hose or
move the tool or a
ep hoses away from
arp edges. Replace any
maged, weak or worn.
lubrication throughout
ol and is the owner's
ailure to lubricate the air
l dramatically shorten the
nd will void the warranty.
This air tool
requires lubrication
tial use and BEFORE and
ditional use.
UBRICATION
ded method for
th an air line lubricator
of the air piping system.
se Campbell Hausfeld air
00AV or equivalent ISO
RICATION
ricator is not used, the
bricated daily.
Disconnect the
air tool from the air
ubricating.
the air tool from the air
tool upside down.
g the trigger, squeeze
ely a 1/4 oz. of Campbell
tool oil in the air inlet. If
switch the forward and
e in both directions.
www.campbellhausfeld.com
After an air tool
has been
lubricated, oil will discharge through
the exhaust port during the fi rst few
seconds of operation. The exhaust port
must be directed away from your body
before applying air pressure.
4. Connect the air tool to the air supply
and cover the exhaust port with a
towel (refer to replacement parts
manual for tool features). Run the
tool in both the forward and reverse
directions, if applicable, for 20 to 30
seconds. Oil will discharge from the
exhaust port when air pressure is
applied.
ATTACHMENTS
Disconnect air
tool from air supply
before changing attachments or serious
injury could occur.
1. Insert stem of grinder attachment into
collet opening (See Figure 2). Make
sure stem is fully inserted.
Grinder
Attachment
Collet Nut
Figure 2
2. Securely tighten collet with
wrenches (supplied with some
models) (See Figures 3 & 4). Apply
one wrench to the collet nut and
the other to the spindle. Turn the
wrench on the collet nut to the right,
simultaneously turning the other
wrench in the opposite direction.
Make sure stem does not slip out of
position.
Figure 3 - Wrenches
To Tighten
Collet Turn
Wrench To The
Right
Always Turn
This Wrench In
The Opposite
Direction
Figure 4
3. Do the opposite of Step 2 to loosen
and change the grinder attachment.
Make sure
attachment stem
is fully inserted into collet opening
and collet is securely tightened. Loose
attach-ments could fl y off during
operation and cause serious injury. Only
use attachments rated for a minimum of
25,000 RPM.
www.campbellhausfeld.com
CL252100AV,
Maintenance
Release all pressure befor
attempting to install, serv
relocate or perform any
maintenance on the air sy
injury and/or property dam
occur.
STORAGE
The tool must be lubricate
storing. Follow the air mot
instructions with an excep
4. Only run the tool for 2 to
instead of 20 to 30 second
more oil needs to remain i
storing.
TECHNICAL SERVICE
For information regarding
or repair of this product, p
1-855-504-5678.
REPLACEMENT PARTS
INFORMATION
For information regarding
replacement parts, call tol
504-5678.
Please provide the followi
• Model number
• Stamped code
• Part number and desc
Address parts correspond
Campbell Hausfeld
100 Production Drive
Harrison, Ohio 45030 U.